Our race car letters  and graphics are easy to install. Follow these steps to insure an easy,  flawless installation.

1. Unfold the side tabs.
2. Clean the surface you are applying the decals to. Be sure to remove all wax, grease and dirt.
3.  Place the decal on the surface using the tabs to hold the decal in place
4.  Measure side to side and up and down for proper alignment. Squeegee one side (tab) down onto the surface.
5. Using a pencil, make a short mark through the unsqueegeed tab and onto the surface.
6. Lift the decal up (using the squeegeed tab as a hinge) and remove the backing paper.
7. Place the decal on the surface, aligning the mark on the tab with the mark on the surface. Squeegee the decal onto the surface, starting from the center and working out.
8. Remove the application tape from the decal and the surface.
9. Remove any bubbles by inserting a small hole in bubble with sharp object (pin or knife). Push air from under decal through hole